sealey 150 vice

fab_welder90 · Nov 25, 2009

i managed to pick up this old sealey 150

http://www.mig-welding.co.uk/forum/photos/3/87e99c8b58b73012653af9856380aca6_3298.jpg?dl=1259181313

any idea where i can get a set of jaws for it?

Also how do i solve the problem of the spindle coming out but the vice not opening, i think there is a spring missing but not entierly sure. any help would be fantastic.
http://www.mig-welding.co.uk/forum/photos/3/c7c1b00899bebb839ef4201e3b6c26e0_3301.jpg?dl=1259181428

Thanks
Daz :welder:

rtbcomp · Nov 25, 2009

fab_welder90 said:
......
Also how do i solve the problem of the spindle coming out but the vice not opening, i think there is a spring missing but not entierly sure. any help would be fantastic.
.......
Daz

I had a vice that did that, IIRC there is a groove in the screw near the handle into which a pin locates. This pin is attached to the moving jaw and it went AWOL, so instead of the jaw moving, the screw just wound out.

brightspark · Nov 25, 2009

u can get the jaws from buck and hickman there bloody dear though 14 to 38 quid for 6inch ones just get sum inch by half.inch bar and weld em in :laughing: