Mr Roo
Member
- Messages
- 586
- Location
- Edinburgh
Wondering if anyone’s had any experience with this particular issue:
cutting round weight plates atm (trial running the machine before we really go to town with it, simple job to test the waters)
inner 2” dia cutout is grand, no issue. Outer cutout (roughly 250mm dia) the torch seems to drop and drag along the last 40mm of the cut before snagging on the dross and needing reset.
on reset, the machine finishes the cut at normal height but has usually already made a mess of the overall cutout.
in this case, i cut 40ish of these and each one looked like that. Tried manually raising torch height (it was dropping to ~92 when it was doing the rest at 89) but machine just wants to fight me when I do that!
anyone got any ideas?
cutting round weight plates atm (trial running the machine before we really go to town with it, simple job to test the waters)
inner 2” dia cutout is grand, no issue. Outer cutout (roughly 250mm dia) the torch seems to drop and drag along the last 40mm of the cut before snagging on the dross and needing reset.
on reset, the machine finishes the cut at normal height but has usually already made a mess of the overall cutout.
in this case, i cut 40ish of these and each one looked like that. Tried manually raising torch height (it was dropping to ~92 when it was doing the rest at 89) but machine just wants to fight me when I do that!
anyone got any ideas?