Tiny Tig job I need doing

[Fred Trevvett]

Hello all, I've got a tiny job which I need doing, two flanges come off the side of a little aluminium bracket that need welding back on. There is probably about 40mm of weld to do, but I can't Tig weld and don't know anybody who can. If there is anyone in the Harrogate or Leeds area who is happy to do it for a tenner or two please let me know...or if nobody is in the area I could post it but not ideal.

I don't have a picture of the bracket, I'll try and upload one tonight, but you can see it on this link, it's the two little flanges at the bottom of the picture: https://www.lsengineers.co.uk/brack...CyQ-UZb7lsdge3KzQ3fSIaeIKq1-2EBQaAlolEALw_wcB

Not bothered about it looking good, just want it stuck well enough that it doesn't break again.

Thanks in advance

 

[Woody.v8]

The cast aluminium looks horrible and will most likely have loads of zinc in it and be a pig to weld.
Good luck though.

 

[gordon stephenson]

Try Ally brazing, Lumaweld etc, Works Very well with practice and only a gas blow torch needed.

 

[Fred Trevvett]

The cast aluminium looks horrible and will most likely have loads of zinc in it and be a pig to weld.
Good luck though.

Shame, maybe brazing will work then. I'm clueless with aluminium so...

Try Ally brazing, Lumaweld etc, Works Very well with practice and only a gas blow torch needed.

Sounds good, I'll give that a go, cheers...

 

[backpurge]

If you don’t have any luck with the above I’m in Guiseley

 

[mdr]

Come on... let's stop this...

 

[wyn]

Make one out of a bit of steel tube and plate.

 

[Bullet2012]

I can make you one £140.00 + vat and shipping

 

[Fazerruss]

I can do it if you're not in a rush. I'm in Ferrybridge.

 

[Fred Trevvett]

Thanks everyone, looks like @backpurge will sort it