MoreWellie
Forum Supporter
- Messages
- 1,885
- Location
- Warwickshire, UK
I believe that 12s connectors are part of the Din series, same as the connectors I bought and pictured in post 5 which would make the answer No unfortunately
- Thread starter MoreWellie
- Start date
I believe that 12s connectors are part of the Din series, same as the connectors I bought and pictured in post 5 which would make the answer No unfortunately
Hilltech Hyds Dermot
New Member
- Messages
- 9
- Location
- Waterford Ireland
can you get any hydraulic shop to switch the hose tails from metric to bsp ,the bsp will have a 60dg cone and will seal mechanically on the cooler, some forktrucks use a 22mm fitting that has to have the bsp cone with metric thread,
MoreWellie
Forum Supporter
- Messages
- 1,885
- Location
- Warwickshire, UK
Still trying to get the right connectors but will bear that in mind to try as I already have some bsp cone fittings of a similar size
Welcome to the forum!
Welcome to the forum!
Hilltech Hyds Dermot
New Member
- Messages
- 9
- Location
- Waterford Ireland
I will have a look tomorrow to see if I take the 12s hose tail out will 3/8 bsp fit through the 20-1.5 nut
thank you
been using this forum with a while and I said I better start to give something back its a very helpful forum 90% of tips or tricks are real life experiences.
thank you
been using this forum with a while and I said I better start to give something back its a very helpful forum 90% of tips or tricks are real life experiences.
I will have a look tomorrow to see if I take the 12s hose tail out will 3/8 bsp fit through the 20-1.5 nut
thank you
been using this forum with a while and I said I better start to give something back its a very helpful forum 90% of tips or tricks are real life experiences.
that’s good to know, I’ve been doing hydraulics at a large ag contractors for 5 years now and thought I’d seen a lot but having to mix bsp and metric on the same hosetail is a new one on me!!! What a nightmare!!
