Lovetherust
Member
- Messages
- 32
- Location
- Notts england
Hi, long time watcher...minimal input-er, but in hope someone can lay down in laymans terms an education to my electrical woes?, so today ive been slapping about with an old 160( cant remember name) and some 3.2mm rods, i know it top end of its limit as it gone through 3 13amp fuses. After reading up on here that the best coarse of action is to up the amperage, thinking a diesel genny, as then i can take it around, my quiry is this, ive seen gennies saying 110v 32amp, but my welder has been using the house 240 supply, do i just change the plug to a 110v and go with that or am i missing something?? Also thinking of getting an oxford oil cooled as when i do weld, its for good stretches of time, how does that fit in with choosing the right generator? I can do alot of things but understand volts and amps just blows my mind! Any help is truely welcome