David Beckett
New Member
- Messages
- 17
- Location
- essex
Hello everyone! I have been MIG welding for many many moons but could never justify the cost of a TIG as much as I always wanted one! However i got myself a bargin TIG, with gas and ally rod and tungston bits for a very cheap. So I am now a TIG owner.
The machine is a WELDSTAR ADT-2000P IGBT AC/DC TIG.
Unfortunatly the machine didn't come with any instructions so I basically have no idea what the knobs do of which there is quite a few! I found a few odds and sods on the internet but the more videos I watch, I hear about ac balance, but aren't sure if my machine has it aswell as other stuff. Makes it all very confusing!
Having searched high and low for instructions on the internet and come up empty I was wondering if anyone could help. What each knob does and what this will effect. Some are obvious but most aren't to me!
Thankyou
The machine is a WELDSTAR ADT-2000P IGBT AC/DC TIG.
Unfortunatly the machine didn't come with any instructions so I basically have no idea what the knobs do of which there is quite a few! I found a few odds and sods on the internet but the more videos I watch, I hear about ac balance, but aren't sure if my machine has it aswell as other stuff. Makes it all very confusing!
Having searched high and low for instructions on the internet and come up empty I was wondering if anyone could help. What each knob does and what this will effect. Some are obvious but most aren't to me!
Thankyou