Memmeddu
Member
- Messages
- 5,384
- Location
- Italia Sardegna
Let's start saying that I hate woodworking
So after 5 days of attempts I finally accomplished to make a wooden handle for a knife I'm making too
Drilled a hole for the pin , put a brass collar.
Epoxy ,drove the blade in place
But while driving the brass pin in place I cracked the handle .
It didn't split a part but it has 4 horrible looking cracks
I've used some D3 vinylic glue in the cracks and pressed together using clamps
I hope it will be enough because I spent the entire day yesterday to make it using only a Stanley knife (no hand planner and too much dust to use a flap disc on the angle grinder )
Any idea if my attempt doesn't work?
I would like to engrave the handle where it's cracked but I believe I can't do that anymore
Ps I can't upload a picture because I don't have one and the handle is wrapped up to avoid it sticking to the clamps
So after 5 days of attempts I finally accomplished to make a wooden handle for a knife I'm making too
Drilled a hole for the pin , put a brass collar.
Epoxy ,drove the blade in place
But while driving the brass pin in place I cracked the handle .
It didn't split a part but it has 4 horrible looking cracks
I've used some D3 vinylic glue in the cracks and pressed together using clamps
I hope it will be enough because I spent the entire day yesterday to make it using only a Stanley knife (no hand planner and too much dust to use a flap disc on the angle grinder )
Any idea if my attempt doesn't work?
I would like to engrave the handle where it's cracked but I believe I can't do that anymore
Ps I can't upload a picture because I don't have one and the handle is wrapped up to avoid it sticking to the clamps