oceanobsession
Member
- Messages
- 321
Hi folks, ive just burnt out the pin housings in a case cx 130 digging bucket,
because they had gone oval, ive welded in place the new housings with 3 mm
low hydrogen rods but ive found that as they cool down im getting some sight
cracks im using a 190amp mosa welder but feel thatts not up to the job,
this is the first time ive done these any advice would be helpfull im thinking
about a genset now maybe cheers oceanobsession.
because they had gone oval, ive welded in place the new housings with 3 mm
low hydrogen rods but ive found that as they cool down im getting some sight
cracks im using a 190amp mosa welder but feel thatts not up to the job,
this is the first time ive done these any advice would be helpfull im thinking
about a genset now maybe cheers oceanobsession.