Good afternoon
I would like some feedback on these welding please I have put pictures of the settings and marked the beads in yellow as this metal plate is a bit messy, with many attempts. Its a 1.5 mm sheet. Gas pressure is 10LPM (hobbyweld 5 - 95% argon + CO2). Basiacally I have changed the wire speend and tried with slightly different torch travel speeds to start with. Increasing the wirespeed caused me to make a hole so I presume it was just too much or maybe my travel speed was too low. I am trying to get a flatter bead but I am not really managing. I was a bit more satisfied with my last two attempts but is the penetration ok?
I would like some feedback on these welding please I have put pictures of the settings and marked the beads in yellow as this metal plate is a bit messy, with many attempts. Its a 1.5 mm sheet. Gas pressure is 10LPM (hobbyweld 5 - 95% argon + CO2). Basiacally I have changed the wire speend and tried with slightly different torch travel speeds to start with. Increasing the wirespeed caused me to make a hole so I presume it was just too much or maybe my travel speed was too low. I am trying to get a flatter bead but I am not really managing. I was a bit more satisfied with my last two attempts but is the penetration ok?