Hi I want to cast a small motorcycle caseing in aluminium. 4”x 3”
X 1”
I made a small furnace out of an old gas cylinder with charcoal as fuel and compressed air.
I t melted the alluminium but did not get quite hot enough to allow me to pour it
Is there a good thread that I can follow on the forum or advice thanks
Should I use green sand or lost wax ?
X 1”
I made a small furnace out of an old gas cylinder with charcoal as fuel and compressed air.
I t melted the alluminium but did not get quite hot enough to allow me to pour it
Is there a good thread that I can follow on the forum or advice thanks
Should I use green sand or lost wax ?