Memmeddu
Member
- Messages
- 4,235
- Location
- Italia Sardegna
Hi
So today I tried to use E6010 on this engine driven welder
3,25mm using 105A
The welder established the arc but the puddle didn't get formed
Someone said that is because the welder is run by a gasoline engine and not by a diesel one
The problem is that this engine driven welder is suitable to use celluloses rods
I tried to crank up the amps to something like 140A started run cold and the flux got burned
So I think that may be are the rods that are garbage
What do you think about?
So today I tried to use E6010 on this engine driven welder
3,25mm using 105A
The welder established the arc but the puddle didn't get formed
Someone said that is because the welder is run by a gasoline engine and not by a diesel one
The problem is that this engine driven welder is suitable to use celluloses rods
I tried to crank up the amps to something like 140A started run cold and the flux got burned
So I think that may be are the rods that are garbage
What do you think about?