KemppiFrog
Member
- Messages
- 4,153
- Location
- Aquitaine
Wookie
This is the first job I have used the welder on, so a bit of a learning curve and in a hurry. I liked what I was getting on the welds, smooth and tidy, with good penetration.
No inductance alteration available, just the volts coarse & fine + wire speed. Need to try the limits to get a feel. But limited until I run a full 32 amp supply back to the board.
This is the first job I have used the welder on, so a bit of a learning curve and in a hurry. I liked what I was getting on the welds, smooth and tidy, with good penetration.
No inductance alteration available, just the volts coarse & fine + wire speed. Need to try the limits to get a feel. But limited until I run a full 32 amp supply back to the board.