10swg weld mesh cutters

[Kent]

I think everyone's correct:

Order to size as close as you can, then 4.5" grinder or 8" croppers for final trim/snagging .

OR measure twice cut on perhaps? if you can't measure cut it on site Imo

 

[bigegg]

OR measure twice cut on perhaps? if you can't measure cut it on site Imo

I meant for the odd bit that needs removing.
I fitted one against a wall where I had to cut a couple of wires to fit around a bolt which went through the window frame.
Just happened to be EXACTLY where I couldn't fit it through the mesh.
I don't mean measure and have it cut it to 4ft, then trim to 1197mm on site - just the odd little square removing

 

[Richard.]

I meant for the odd bit that needs removing.
I fitted one against a wall where I had to cut a couple of wires to fit around a bolt which went through the window frame.
Just happened to be EXACTLY where I couldn't fit it through the mesh.
I don't mean measure and have it cut it to 4ft, then trim to 1197mm on site - just the odd little square removing

I knew exactly what you meant mate. Some of us don’t have crystal balls.

 

[bigegg]

I knew exactly what you meant mate. Some of us don’t have crystal balls.

I know, it's just the way you're stood.

 

[Richard.]

I know, it's just the way you're stood.