angellonewolf
Member
- Messages
- 8,164
- Location
- bristol england
you can weld cast with the right rods ? i did even weld a cast chimnea with 6013 i think and it held and done a few fires in itits cast iron
you can weld cast with the right rods ? i did even weld a cast chimnea with 6013 i think and it held and done a few fires in itits cast iron
The small Merlo was a "mistake"
When are you gonna contribute?should know by now theres some crackerjacks on here with barmy ideas
4 scaffolding planks and scaffie tube rollers . just got a rather large safe heavier than that out of my house and over the steps using them . just me and my mate . i have a real; heavy diesel compaction plate i put it in and out of my trailer on my own regular the same wayWhen are you gonna contribute?
I had 4 very hefty blokes offer to assist when I was turning my table upright. I had it shipped to me on a pallet upside down as requested.walk in to local biker pub pick the 4 bigest of them call them all sissys and that even 4 of them could not even move a small 2 foot x 2 foot table from your van to the work shop 20 feet away if they do it you will buy all 4 a double jackds each
ps this could also get your head kicked in but ive allway found biker people to be very friendly people
I can personally guarantee the effectiveness of this technique when it comes to emptying the back of a van.Until somebody tries this how will we know?
Once out the van, it has to go up 3 flights of stairs to a workshop......One thing not clear is where is the van/table is in relation to it's final destination? That is the main point for removal? Without the means to lift then it'll have to be slid out onto something the same height, then what?