Difference between revisions of "Weld Testing"

From Welding Wiki
Jump to navigation Jump to search
(Created page with "{| |- | ==Types of Weld Testing== The majority of weld testing and inspection can be separated into two categories: Destructive Testing, and Non-Destructive Testing. We will...")
(No difference)

Revision as of 14:55, 30 January 2021

Types of Weld Testing

The majority of weld testing and inspection can be separated into two categories: Destructive Testing, and Non-Destructive Testing. We will be taking a look at some of the more commonly used methods.

One method that could fall into either category is load testing

Loadtestingcrop1.JPGLoad Testing

Non-Destructive Testing

There are numerous methods of NDT, some are reasonably simple, but others require specialist operators and expensive equipment, such as X-ray testing

There are also more simple methods such as dye penetrant testing, that can be carried out with minimal equipment, and in most workshops.

More advanced systems use Florescent penetrants

Flouro3.JPGFlorescent Penetrant

Destructive testing

Destructive testing is usually a cheaper method of inspection. It lends its self to mass produced parts, where sacrificing one or two components for testing is acceptable. It is quite useful for setting up welding equipment. It is also a good learning tool during training courses, as it allows the students to do lots of testing at minimal cost, and is often easier to understand than some of the NDT methods.

The two most common tests used in training are Macro Etch testing, and Root and Face bend testing.

Another easy test to carry out is a Nick break test.

Steelmacro.JPGMacro Etch Testing