Hoping someone can help with a problem. I replaced the rotary switch on my welder a couple of years ago, it worked fine, I took photos of the wires and their positions when the new switch arrived replacement was easy and it worked fine. Around six months ago the switch internals collapsed again (these tumblers are quite crappy). I took the switch off to try and open it up and repair it, thinking I would remember where the wires went. I gave up repairing the switch as it was way too fiddly for my big hands. So six months pass and my mate gets a job in China, and has just sent me two replacement rotary switches but when I looked for my original photos of the first time I did this, I had deleted them. Can anyone help with photos of how to connect it all back up.
