Terry2sticks
New Member
- Messages
- 2
- Location
- Midland’s UK
Hello all.
First of I’m new here and my first post so would like to say hello.
I brought a 2nd Clarke pro 90, I’m not a welder but I do the odd bit with a stick but fancied a mig.
At first I thought my settings wasn’t right but then I took an other look at the tension and noticed the feed wheel runs, then stops, then runs and stops, regardless how fast I have the wire feed step up, it just doesn’t run continuously, I’ve tighten the tension, I’ve loosened the tension. Removed the wire completely and re-feed nothing seems to work.
Is there any known issue that causes this?
Regards Terry
First of I’m new here and my first post so would like to say hello.
I brought a 2nd Clarke pro 90, I’m not a welder but I do the odd bit with a stick but fancied a mig.
At first I thought my settings wasn’t right but then I took an other look at the tension and noticed the feed wheel runs, then stops, then runs and stops, regardless how fast I have the wire feed step up, it just doesn’t run continuously, I’ve tighten the tension, I’ve loosened the tension. Removed the wire completely and re-feed nothing seems to work.
Is there any known issue that causes this?
Regards Terry