series2
Member
- Messages
- 312
- Location
- Cheshire, UK
I need to make a winch tray for the front of my truck. This will require a few butt welds on 6mm m/s plate, I have a 150A arc welder, and I have access to a 150A mig welder. My question is will I be able to to get good weld penetration on the 6mm plate. It would be possible to 'V' the plate at the joins, and weld from both sides.
I can't use an off the shelf tray, as the vehicle is not standard and they won't fit (I've tried).
I've done stuff like this before, but at that time had access to bigger welding plant.
I can't use an off the shelf tray, as the vehicle is not standard and they won't fit (I've tried).
I've done stuff like this before, but at that time had access to bigger welding plant.