Where to get a decent trolley

[nickburt]

I feel a bit embarresed with this one. The correct answer is custom build, but I just never seem to get the time . So, where can I get a decent trolley for a Clarke 160 Turbo. Preferably with a couple of shelves for stuff like clamps, snips etc... etc..

 

[rusty69bus]

decent trolley

i'm sure someone would build you one for a price, but build your own would be better gives you practice and a smile

 

[JML]

If you feel like lashing out £200 Cebora do a nice trolley for their inverter MIGs


http://www.wilkinsonstaronline.com/moreimages.php?itemid=ms2035

 

[knoba]

My local welding supplier sells complete trolleys for £40. They seem OK. Try your local?

 

[shenion]

Doesn't Clarke sell the same one as this?

Was a nice cart and cheap from a local discount shop.

 

[fingers99]

Clarke -- or Machine Mart -- sell ones very like that.

 

[shenion]

If it is the same one, then the holes for the back support are drilled measured from the wrong end

It worked well, seemed a bit narrow, but it never fell over. I had the shelves filled with wire, tips, clamps, brushes and other stuff. Was real nice.

Of course the best are home made

One tip: the welder tended to slide around as you tend to drag it by the welder handle. I drilled two holes and put bolts that stuck up and went in the recesses in the feet.