stumpy75 Member Messages 47 Location wales Sep 16, 2014 #1 Ho guys i need to make a new complete bukhead panel for my austin mini its 922mm wide 715 long the original is quite thin i was thinking of using 1.5 mm is that ok or Two thick i wil need to replce the tiè board as well
Ho guys i need to make a new complete bukhead panel for my austin mini its 922mm wide 715 long the original is quite thin i was thinking of using 1.5 mm is that ok or Two thick i wil need to replce the tiè board as well
P piman Member Messages 1,895 Location Oswestry Shropshire Sep 16, 2014 #2 Hello Stumpy, use the same thickness as original, 18 gauge or maybe even 20 gauge (1mm or 0.8mm approximately I think?) 1.5mm is over the top in my view? Alec
Hello Stumpy, use the same thickness as original, 18 gauge or maybe even 20 gauge (1mm or 0.8mm approximately I think?) 1.5mm is over the top in my view? Alec
langy langys rodshop Messages 6,087 Location London Sep 16, 2014 #3 As piman said, its plenty good enough, but remember shapes give strength
stumpy75 Member Messages 47 Location wales Sep 16, 2014 #4 Pic of where the panel will be going Aldo will form a full width bulkhead box.
stumpy75 Member Messages 47 Location wales Sep 16, 2014 #7 It will need to go down to the toè board join and then fan a new forgiare ime looking to get swages put into the panel for strength ad well
It will need to go down to the toè board join and then fan a new forgiare ime looking to get swages put into the panel for strength ad well
