Well after just over a year of buying the Clarke 160TE I finally got round to buying the agroshield light gas bottle so I could have a play.
My runs on a sheet "seem" ok but when I tried to weld two bits together I had varying results. Sometimes I would do a nice run, then I'd burn a hole in the two pieces.
If I hold the trigger down and do a run it pulses, is this right too?
Settings were:
Power: 1
Max/Min: Min
Wire feed speed: 5
L/PM: 8-10
Here's some pics too
Top of joined pieces
Bottom of joined pieces
Top of another join with straight runs either side
Bottom of same
Still off for another week so plenty more time to play
My runs on a sheet "seem" ok but when I tried to weld two bits together I had varying results. Sometimes I would do a nice run, then I'd burn a hole in the two pieces.
If I hold the trigger down and do a run it pulses, is this right too?
Settings were:
Power: 1
Max/Min: Min
Wire feed speed: 5
L/PM: 8-10
Here's some pics too
Top of joined pieces
Bottom of joined pieces
Top of another join with straight runs either side
Bottom of same
Still off for another week so plenty more time to play