Rain finally stopped so despite a little breeze I fired up the welder. It’s a Bester 190 C and I’m using the Lincoln Supramig 0.8 wire.
I keep getting the MIG wire stuck to the work piece and I get a glob of metal left on the wire. I’ve tried increasing the wire speed but it blows a hole through the metal sheet (2mm) and still sticks a bit.
The workpiece is clean and earth properly. Gas is at 10 l/min.
Is there anything standing out that I’m doing wrong? Thanks.
I keep getting the MIG wire stuck to the work piece and I get a glob of metal left on the wire. I’ve tried increasing the wire speed but it blows a hole through the metal sheet (2mm) and still sticks a bit.
The workpiece is clean and earth properly. Gas is at 10 l/min.
Is there anything standing out that I’m doing wrong? Thanks.