Welding Level 3 help please

[side-show-bob]

Hi all i have just completed my city and guilds Lvl 2 in Tig welding, i am now going to start Lvl 3 and have a copy of the book with the test peices in it and i need some help please on what it is asking for..

I want to practice before the start of the course in september so need your help as i wont see any teachers until septembers start.

So i have to do the following and the bits in BOLD are the bits i am struggling with:

Assignment 1
Produce a single-vee pipe butt weld in the PA flat-rotated (ASME 1G) position

Assignment 2
Produce a single-vee pipe butt weld in the PC horizontal (ASME 2G position.

Assignment 3
Produce a single-vee pipe butt weld in the PF vertical-upwards (ASME 5G position.

Assignment 4
Produce a pipe tee fillet weld in the PF vertical-upwards (ASME 5F) position.

Assignment 5
Produce a single-vee pipe butt weld in the H-LO45 inclined ASME 6G position.

 

[knoba]

Well done on passing!

PA, PB, PC, PF, etc are ISO and EN designations.

Good resource on ASME, ISO & EN definitions here.

City & Guilds 3268-308 Level 3 Award in Tungsten Inert Gas (TIG) welding (pipe) PDF
is here. Diagrams of positions included ...but you may need 'accessories' to see it

 

[Delgado]

Here's a chart (covering all the positions except 6GR and J-LO 45/H-YO45), might need to zoom in a bit, couldn't post it any bigger.


View attachment en weld positions.bmp

 

[Wedg1e]

Think I have a copy of ASME V in .pdf if anyone gets stuck...

Those test blocks shown in the sections.... we make and sell those.

 

[Delgado]

Think I have a copy of ASME V in .pdf if anyone gets stuck...

Yes please

 

[justin]

me too please

 

[side-show-bob]

Think I have a copy of ASME V in .pdf if anyone gets stuck...


i will please

 

[Wedg1e]

I've uploaded the relevant files to a spot on my own website but when I try to get at them it gives me a HTTP 403 error, I must be doing something wrong
Unlikely to be able to email directly as they're quite capacious files.
Working on it...