Welder maintenance day

[God mode restorations]

Today is welding equipment maintenance day. Been welding for the last couple of weeks so a good clean down of this lot is needed

 

[bourbon]

looks OK to me. Go spend your time doing something you enjoy, life is too short

 

[RWD3M]

Where's the 'before' picture?

 

[God mode restorations]

Where's the 'before' picture?

That is the before picture.

 

[RWD3M]

That is the before picture.

Then what @bourbon said!

 

[Parm]

Welcome to come over to mine if your bored? Plenty of things to clean in the play pen

 

[Lewis_RX8]

What you doing to it , If mines lucky I open it up and get the air line to blow all the sh1te out

 

[roblane65]

Well you do pamper them then .

 

[God mode restorations]

All done. A good clean. Rebuild kit for the torch. New plug. Look after ya gear and ya gear looks after you.

 

[frank horton]

who was it on TOP GEAR that named his spanners......????

 

[Lewis_RX8]

who was it on TOP GEAR that named his spanners......????

James may I think

 

[Bryan Williams]

What? I missed this.. Is it a bank holiday?

 

[Eric the chicken]

Frequently leave radio 4 on in the workshop to inform my tools of events and stop them feeling neglected when I’m not there

 

[eLuSiVeMiTe]

I blow the dust off my tools with a leaf blower now and again.

 

[James1979]

I blow the dust off my tools with a leaf blower now and again.

I do that to clean the truck out

Open both doors and let rip

 

[God mode restorations]

A little maintenance goes a long way. I appreciate that welding workshops probably don't get the time to do it but I have always done it and it gets used alot. Not bad for a machine that's 5+ years old

 

[eLuSiVeMiTe]

I do that to clean the truck out

Open both doors and let rip

Did it in a kitchen last week. Swept up well. Opened the 5m bifold doors right up and blew all the dust outside.

 

[eLuSiVeMiTe]

A little maintenance goes a long way. I appreciate that welding workshops probably don't get the time to do it but I have always done it and it gets used alot. Not bad for a machine that's 5+ years old

Didnt recognise you with the name change mate

 

[Maker]

Not bad for a machine that's 5+ years old

Looks brand new! I might have to wipe mine down now, it's your old one so it's probably feeling a bit neglected by comparison.

 

[Parm]

Didnt recognise you with the name change mate

Spill the beans my man