Evening all,
I have broken a hub nut on one of my jalopies (a 1957 Bedford CA - same chassis as Vauxhall Wyvern) and trying to track down the size (and a replacement) is proving tricky...
Outside dia. of the half shaft threaded doofer is exactly 13/16" across the peak of the thread.
TPI is 16
I've tried:
7/8" BSF - it went on one turn so dia. Is about right, but wrong TPI
7/8" UNF - slightly too big and wrong TPI
3/4" UNF - too small
Any ideas before I scrap the bloody thing??
Cheers,
Steve
I have broken a hub nut on one of my jalopies (a 1957 Bedford CA - same chassis as Vauxhall Wyvern) and trying to track down the size (and a replacement) is proving tricky...
Outside dia. of the half shaft threaded doofer is exactly 13/16" across the peak of the thread.
TPI is 16
I've tried:
7/8" BSF - it went on one turn so dia. Is about right, but wrong TPI
7/8" UNF - slightly too big and wrong TPI
3/4" UNF - too small
Any ideas before I scrap the bloody thing??
Cheers,
Steve