Hello welders!
I'm doing a project and I would be really happy if someone could verify if this table makes sense. I couldn't verify it using my knowledge.
The table provides reference values for projection welding parameters (current, time, and pressure) based on the material and thickness of the parts being welded. I know that these values serve as an initial reference and may vary depending on the equipment and specific conditions of each application but would be really good if I could know if the table is acceptable for me project.
Thank you!
I'm doing a project and I would be really happy if someone could verify if this table makes sense. I couldn't verify it using my knowledge.
The table provides reference values for projection welding parameters (current, time, and pressure) based on the material and thickness of the parts being welded. I know that these values serve as an initial reference and may vary depending on the equipment and specific conditions of each application but would be really good if I could know if the table is acceptable for me project.
| Material | Thickness (mm) | Current (kA) | Time (cycles) | Pressure (N) |
|---|---|---|---|---|
| Carbon Steel | 0.5 | 2.5 | 10 | 1000 |
| Stainless Steel | 0.5 | 3.0 | 12 | 1200 |
| Aluminum | 1.0 | 4.0 | 15 | 1500 |
| Copper | 1.5 | 5.0 | 20 | 2000 |
Thank you!
