To weld tunsten carbon tips to cicular saw

[desmo11225]

Hello everyone , would someone tell me where I can get a few Tungsten carbide tips welded to a 10/ 12 inch dia .circular saw . Thank you folks desmo11225

 

[eLuSiVeMiTe]

Normally braised aren't they?

 

[eLuSiVeMiTe]

Any local sharpening places. They may be able to either do it or point you at someone kocal

 

[The_Yellow_Ardvark]

They are brazed or silver soldered on.

But the cost of that is more than a new blade, they will subject the old blade to a series of tests to see if it is worth it.

Buy new.

 

[AndersK]

Normally braised aren't they?

Little hard to digest aren't they?

 

[eLuSiVeMiTe]

Little hard to digest aren't they?

Aye. I was dubious as I wrote it but knee deep in sketchup right now and cba to check.

Didn't look right with the z when I typed it.

 

[CompoSimmonite]

Probably not worth the cost of "repairing" such a small blade and new will possibly be cheaper.

 

[desmo11225]

Hello everyone , Thank you for your prompt replies and would you believe it I was able to talk to our local saw sharpener and got myself fixed up after trying for hours , Thank you everyone desmo11225

 

[pedrobedro]

Little hard to digest aren't they?

Yes but they steak their reputation on results.

 

[gaz1]

Hello everyone , Thank you for your prompt replies and would you believe it I was able to talk to our local saw sharpener and got myself fixed up after trying for hours , Thank you everyone desmo11225

all this and no explanation on whats happening?

id have just bought a new one and resharpened the new blade when needed or thats what seems to be done at best of times