tig welder needed near bromley, kent (se london)

[Henrik]

I need to have the outlet from my thermostat housing turned around 90 degrees (so that it faces the drivers side wing) in this picture:

The housing is the thing that has the black cable lying on top of it, just to the left of the shiny fuel rail in the pic. It's aluminium, and probably cast.

Ideally you'd need to be close'ish to Bromley and available to do it in an evening and/or a weekend (as I currently work long hours and can't travel).

Anyone up for it?

 

[pedrobedro]

You could remove it and cut it to what you want then send it to someone via the postal service.

 

[Henrik]

That's a good point

Anyone outside SE london / NW kent?

 

[scott0031]

I can do it for you if you like Henrik.


Kinds regards,


Scott

 

[Ashg]

humm that looks like a saab b234 to me putting it in an escort by any chance? what box did you go for r28?

im in rochester. have put a b204 in my kit car

built the whole car from scratch ( chassis, body work, exhaust system, suspension, yes i mean everything )

anyway if you need any tig doing ali or what ever then give me a shout

 

[Henrik]

It is indeed a b234, but into an mx5!

Nice looking project there, i have plans to build one within the next 20 years or so

 

[Henrik]

Sorry, forgot about the box...

Its a bmw gearbox (zf manual from a 328) with a custom bellhousing. Clutch is a mix of saab viggen cover with a bmw racing paddle disc onto a b204 flywheel.

 

[Ashg]

little bit of an update.

what did the box set you back? im using an r28 off a 3.0l omega.

interesting choice mx5. i just broke one down to build anothere kit car. if you need any body panels, roof random bits etc let me know.

 

[Henrik]

You should definitely hop over to www.uksaabs.co.uk and post a thread in their projects section.

They'll go mad over your car, i think

I actually bought a kit car magazine yesterday - some of the kits aren't too badly priced, are they?