TIG Cooler connections

[pawsnizzy]

Hi All,
Not sure if I've put this in the right place, if not - sorry!

I have a TIG cooler with 3/8 bsp connection on the top near the front. For various reasons, I need to come off these at a right angle so that they're facing front - 90 deg elbow is obvious but unsure if I need to seat onto the female cone on the bulkhead. If so what kind of elbow/fitting do I need?
I would like to keep this as low profile as poss. due to space available.

I apologise to any sensitive souls that find this post offensive

 

[Munkul]

BSP hydraulic conical fitting probably a male to female swivel. This will give you the proper cone seat.

https://www.flowfitonline.com/hydra...MIntXwkevY6QIVKYBQBh3SWQkcEAQYCCABEgIe_fD_BwE

 

[pawsnizzy]

BSP hydraulic conical fitting probably a male to female swivel. This will give you the proper cone seat.

https://www.flowfitonline.com/hydra...MIntXwkevY6QIVKYBQBh3SWQkcEAQYCCABEgIe_fD_BwE

Thank you, you magnificent beast

 

[gt6s]

I apologise to any sensitive souls that find this post offensive

Sensitive Me ? Do not think so. I do however get rattled when someone fails to grasp even the simplest of direction. This post FINE.

 

[Munkul]

Thank you, you magnificent beast

I am, aren't I

 

[pawsnizzy]

I am, aren't I

To be fair, probably not but I'm a really nice guy