First Post! Please note I am not a welder by trade but I repair them...
Anyone out there have a Telwin Plasma 60HF?
I'm repairing one and have only moderate success - it no longer smokes
but the HF arc 'dies' without actually starting the cut.
I first had it apart in November and have only just returned to it...and there is a connector coming from a temperature sensor on the heat sink that I am not sure where it connects to.
If anyone has one, could they;
a) pop the case open and check/post a picture of where the 2-pin connector with the grey/orange wire goes;
b) send service manual with schematics...
Thanks!
Anyone out there have a Telwin Plasma 60HF?
I'm repairing one and have only moderate success - it no longer smokes
but the HF arc 'dies' without actually starting the cut.I first had it apart in November and have only just returned to it...and there is a connector coming from a temperature sensor on the heat sink that I am not sure where it connects to.
If anyone has one, could they;
a) pop the case open and check/post a picture of where the 2-pin connector with the grey/orange wire goes;
b) send service manual with schematics...
Thanks!
