Tapered pin help

[steve_s]

I need to do a repair on my shaper there is a tapered pin holding one part Iv driven it out and its a bit damaged not all me I have measured it as best as i can its
4.11m 0.163 5/32?
4.79m 0.189 3/16?
and around 2 1/4 inch long

Now I have no experience of taper pins and the measurements are as near as I can get with the damage
Iv done the usual google searches but am unsure of what Im looking for.
Iv found some on fleabay that I thnk are near but not long enough

Thanks in advance

Steve

 

[Rocketman]

Look's like the standard taper pins are 0.6 degree/s where as your dimensions are more like 0.34 degree/s

 

[grim_d]

How damaged is it? Can't you just file the high spots off and reuse?

How critical is the thing it's securing? If you feel it's a bit loose perhaps a bit of loctite?

Or is it now doing its best impression of a banana?

 

[gordon stephenson]

If the old pins are re-useable don't oil them before fitting.

 

[reedx]

Doesn't sound like a standard imperial taper pin to me. They are sized from the large end and have a 1:48 taper.
Colin