Guys can any of you advise if you would expect any problems stud welding onto zinc plated material using a steel plated stud?
Is it possible to reduce / eliminate the burn marke caused by stud welding as the problem we have the part is painted on the burn mark side after weld so if we were to dress the mark it could show through once we've painted the panel.
Any advice is appreciated
Is it possible to reduce / eliminate the burn marke caused by stud welding as the problem we have the part is painted on the burn mark side after weld so if we were to dress the mark it could show through once we've painted the panel.
Any advice is appreciated