St/St tube

superls · Dec 13, 2010

Hi, i need a bit of assistance,

im in need of some 1 1/2 inch stainless tube, need about 1 meter.

ive been quoted £13 for 1 meter at a local company thats for 16 gauge, i have been quoted £10 per meter at another company but have to have 3 meters, which will take me years to use.

do them prices seem ok? anyone know anywhere cheaper?

Cheers Scott

Furry Freak · Dec 13, 2010

Have you tried Twigg in Matlock? Difficult to beat their prices and you can usually have as much or as little as you like. Does it have to be SS or could it be galv? They have a great oddment section which is where I get all my stuff. Dirt cheap. Ring their steelyard, if you haven't done so.

Remember they deliver daily to Chesterfield, free.

FF

rkde · Dec 13, 2010

They are not too bad a little on the high side but for a second handler its about right, I think its about £6per meter but they will be adding the shipping and handling cost to you. You can try custom exhaust manufactures they maybe cheaper

superls · Dec 14, 2010

Furry Freak said:
Have you tried Twigg in Matlock? Difficult to beat their prices and you can usually have as much or as little as you like. Does it have to be SS or could it be galv? They have a great oddment section which is where I get all my stuff. Dirt cheap. Ring their steelyard, if you haven't done so.

Remember they deliver daily to Chesterfield, free.

FF

hi, yes it needs to be stainless, ill try twiggs, ive always found them expensive in the past, esp when i wanted an RSJ for my kitchen.
ill give them a buzz cheers

weldingscotty803 · Dec 14, 2010

think i may have some tube at work. will check tomorrow. your only round the corner from me. your at the bottom of brim arent ya, i'm in new whitt. will let you know tomorrow

superls · Dec 15, 2010

weldingscotty803 said:
think i may have some tube at work. will check tomorrow. your only round the corner from me. your at the bottom of brim arent ya, i'm in new whitt. will let you know tomorrow

cheers mate that will be really good, you dont have any plate do you aswell? 6-8mm, could do with a piece about 70x310mm

yea im at the bottom of brim

St/St tube

superls

Member

Furry Freak

Member

rkde

Me called Richard

superls

Member

weldingscotty803

what you staring at??????????

superls

Member