People may have read my previous post about modifications iv carried out on my welder, it's a lumber Jack mig master.
Mods I've carried out so far, fit a euro torch, fit a rectifyer (AC-DC), fit a coustom coil and made it so I can change the polarity for welding.
My problem is now the solenoid, I was hoping to run it off the 12v trigger return which is 12v but when I connect the solenoid it stops the welder from working, so the the wire feeder don't run and I get no voltage at the mig tip.
So now I'm a little lost on what to do,
I did wonder if running a relay off the mig trigger would work then have the solenoid run off is own PSU
The trigger wire is the bottom right any advice would be appreciated
Mods I've carried out so far, fit a euro torch, fit a rectifyer (AC-DC), fit a coustom coil and made it so I can change the polarity for welding.
My problem is now the solenoid, I was hoping to run it off the 12v trigger return which is 12v but when I connect the solenoid it stops the welder from working, so the the wire feeder don't run and I get no voltage at the mig tip.
So now I'm a little lost on what to do,
I did wonder if running a relay off the mig trigger would work then have the solenoid run off is own PSU
The trigger wire is the bottom right any advice would be appreciated