solder on tube ends, what do you call them?

[graffian]

I have an awkward oil line to connect up, going to have to either put a curved bit of kunifer
into it or, well not really though of a neat alternative.
I want a 135degree bend in as little space as possible, which a bent bit of kunifer with a conical end soldered onto it might well do
.
What do you call the ends soldered onto hard lines to go into 60degree cone seats? It goes on a
1/4bsp oil tank fitting.
I was just going to get a bit of 1/2" brass and make one but if I can buy them..


And on the same topic I remember someone who was remaking oil lines with these on silver soldering them.
Soft solder no good?

Heres a sketch of what I want:

 

[colnerov]

Hi, They are called solder pipe nipples and are usually silver soldered.

Colin

 

[8ob]

Not worth the effort making them https://www.customfittings.com/bsp-p-cone-seat-nipple-for-socket-weld

 

[graffian]

Cheers, all I could find was one crappy picture from the pintrest site.
The right words make a difference!

But after having a good look I want the bend tighter than I can bend, so I am going to have
to make a make a little billet bend, so I am going to go score a bit of 1/2" brass on ebay.

 

[colnerov]

Hi, Have you got room to get a banjo bolt and then a 45 or 90 degree banjo elbow in?

Colin