I am back. it seems the smallest item is the hardest to create..
I need a quick 3D printed adapter for the want of another word..
Its to go between an epson cartridge (the hole in the bottom and in my case a piece of rubber tube.
so effectively its a tube about 20mm long going from 3mm to 5mm and back to 3mm.
But do you for the life of me think I can model one. it seems simple but not to me it aint.
I attach a photo of exactly what is needed (the yellow thing on the blue kitchen roll.) but doing it that way would need my measurements to be spot on. doing a simple tube going from 3mm to 5mm and then back to 3mm with a hole up the center allows me to stick it in the rubber tube and also in the bottom of the cartridge without messing.
If any of the 3D modellers could help out that would be great
I need a quick 3D printed adapter for the want of another word..
Its to go between an epson cartridge (the hole in the bottom and in my case a piece of rubber tube.
so effectively its a tube about 20mm long going from 3mm to 5mm and back to 3mm.
But do you for the life of me think I can model one. it seems simple but not to me it aint.
I attach a photo of exactly what is needed (the yellow thing on the blue kitchen roll.) but doing it that way would need my measurements to be spot on. doing a simple tube going from 3mm to 5mm and then back to 3mm with a hole up the center allows me to stick it in the rubber tube and also in the bottom of the cartridge without messing.
If any of the 3D modellers could help out that would be great