scott_shot
Member
- Messages
- 119
So last night in the garage a mate turned up who i hadn't seen in a good year i asked him to give me a hand, Not much he could do but he said yes gladly
I was to cut my front hoop at 45, anyway i cut one side one way and the other the opposite way.
ops: was not paying attention, and i usually spend more time than necessary checking bla bla bla anyway stupid error and i know not to work with a mate again as i just didn't put 120% concentration into it
So i am thinking an inner sleeve should do the job, i have some that slides in with a 0.5 mm gap between,will that be ok? Also not sure about he gap to leave as the rol bars are 3.2mm thick and the sleeve is 2.5 thick so alot to weld too. I also think the jon could maybe be at an angle to aid strength.
I have some spare tube but not much and will practice a few time its just any extra tips form you guys = minimise the practice/ Better result
CHeers troops
I was to cut my front hoop at 45, anyway i cut one side one way and the other the opposite way.
ops: was not paying attention, and i usually spend more time than necessary checking bla bla bla anyway stupid error and i know not to work with a mate again as i just didn't put 120% concentration into itSo i am thinking an inner sleeve should do the job, i have some that slides in with a 0.5 mm gap between,will that be ok? Also not sure about he gap to leave as the rol bars are 3.2mm thick and the sleeve is 2.5 thick so alot to weld too. I also think the jon could maybe be at an angle to aid strength.
I have some spare tube but not much and will practice a few time its just any extra tips form you guys = minimise the practice/ Better result
CHeers troops
