Sip 195 turbo mig wiring problems

[CROWE]

Hi I've got a sip 195 turbo mig welder the wire feed has stopped working on further inspection there are two broken wires one goes to the torch trigger and the other to the wire feed motor they both go to the main coil looking component. Is this repairable as they seem to go inside the coil and I can't seem to see where to resolder them on as they go inside and also which wore goes where as both are broken? Can anyone help please? Andy

 

[Robotstar5]

Can you post a pic of the affected area?

 

[CROWE]

Hi

The wires go into like a square coil I would say it was the transformer? I just can't see how I would get a soldering iron in to resolder the wires on as they go right inside the coil? I will post a pic when back off my hols next week.

 

[skotl]

Do you mean wires going into one of the two big beasties at the bottom of this picture?

It's very unusual for a wire to break inside a transformer and, if it has, you're probably correct that it's going to be difficult to repair.