Saving my welder

[pothole]

Hi new to the forum I hope someone can help me.
I have a clarke MIG EN90 not been used for a while I went to use it but the wire had rusted into the swan neck and all into the welder. Can I get a replacement blue pipe that the wire goes through as I cant see any way of getting it out as both ends have snapped inside thanks,

Tony

 

[daf45]

You can replace the liner - they're like a service part.
Probably best to use a steel one rather than nylon.
You could PM weldequip - a member here who could supply the part and advice on fitting. Obviously bin the rusty wire.

 

[patreusch]

open torch up or stick something in there then blow some compressed air in there