I purchased a 20mm and 22mm Roabroach TCT cutters from Amazon but internal diameter of the cutters are 8mm compared to all the other brands I have which are 6mm I can't seem to find out as to where I could purchase one, I rang Magdrill and they couldn't help. I didn't know that there were different sizes until now any help would be appreciated.
- Thread starter Claud 1
- Start date
wyn
Member
- Messages
- 3,733
- Location
- Cardiff
It does turn out to be a bit of a nightmare finding you don't have the right diameter/length pilot pin.
I have sometimes made my own.
Here are a few 8mm for sale
I have sometimes made my own.
Here are a few 8mm for sale
Munkul
Jack of some trades, Master of none
- Messages
- 7,788
- Location
- Cumbria
There's only two diameters of Rotabroach Raptor cutter pins, the skinny one for 11-12mm and the standard one for everything else up to 52mm. Now I'm sure that the standard diameter is 1/4"/6.35mm, because that's what size drill we'd put in if we need a bit more support for the cutter.
Now I'm sure there are older, different pins for older Rotabroach cutters pre-Raptor, and different brands, I have some, but I can't remember what they are
Now I'm sure there are older, different pins for older Rotabroach cutters pre-Raptor, and different brands, I have some, but I can't remember what they are
Th
Thanks for that information, strangely enough I looked at that website this morning but being the anti Ebay person I am I decided not to proceed hence the post on this forum, so now just ordered one and hopefully will be the right one. I have had my Magdrill for about 18 years maybe a bit longer but I have not come across this before, I am grateful for the information.There's only two diameters of Rotabroach Raptor cutter pins, the skinny one for 11-12mm and the standard one for everything else up to 52mm. Now I'm sure that the standard diameter is 1/4"/6.35mm, because that's what size drill we'd put in if we need a bit more support for the cutter.
Now I'm sure there are older, different pins for older Rotabroach cutters pre-Raptor, and different brands, I have some, but I can't remember what they are
Yes that's an option but I have already purchased the cutters and to be quite honest there is no comparison in speed and quality with drill bits, no point in having a mag drill if you are using drill bits as a pillar drill would suffice but it takes forever
no , i meant use a drill bit as the guide pin if you dont have one ..
Sorry I misunderstood I will try that until I Get the one I ordered.
Yes that's a thought I will have to wait for the one I ordered, but that might be a while as we are blocked off with snow at the moment.
AndersK
Member
- Messages
- 1,490
- Location
- Sweden
Just weld a washer on it
Do you supply these pins
Jim Davey
R H Davey Welding Supplies Ltd
- Messages
- 5,736
- Location
- Southampton
Yes that was a picture of one on my desk.
Could you give me a cost for 2 sent to AB42 5PX thanks
nope , will work the very best , granted not ideal but it will keep you going.
Jim Davey
R H Davey Welding Supplies Ltd
- Messages
- 5,736
- Location
- Southampton
PM me an email address please and I’ll quote you on Monday.
