sam_shelton
Member
- Messages
- 18
Hi guys,
Just found your forum and would like to say its great! I have just bought a sealey supermig 250 and want to change the shroud on the eurotorch. I have purchased one from sealey but it is not obvious how to remove it. It is a push on type but the old one only the outer shroud is lose.
Any advice on removing and refitting one would be much appreciated.
In addition I am not sure how to refit the wire to the machine and the instructions are useless. I am used to small machines but this one has a 15kg roll on it. The diagram shows some kind of spacer but as far as I can tell there is no spacer on my machine. Any clues?
Thanks
Sam
Just found your forum and would like to say its great! I have just bought a sealey supermig 250 and want to change the shroud on the eurotorch. I have purchased one from sealey but it is not obvious how to remove it. It is a push on type but the old one only the outer shroud is lose.
Any advice on removing and refitting one would be much appreciated.
In addition I am not sure how to refit the wire to the machine and the instructions are useless. I am used to small machines but this one has a 15kg roll on it. The diagram shows some kind of spacer but as far as I can tell there is no spacer on my machine. Any clues?
Thanks
Sam