Problems finding half round

[Chipper]

I was hoping to be able to find some half-round bar, about 16mm to 20mm wide, yer fully rounded (feather edge?), not the square edge stuff.
Either stainless or mild, just a couple of 50cm lengths.

Haven't had any joy with local suppliers or web shops as yet, anyone got any ideas? Or got some they might want to swap for folding Earth Pounds?

Actual size isn't critical, it's for a cosmetic thing. Cheers...

 

[jugs]

Mill a flat on some std bar ??????, for the amount you want - quicker/cheaper

 

[Chipper]

Hi jugs, did sorta think about that, except the last time I trawled round the local shops none of 'em was remotely interested in little stuff... But I'll try again if needs be, cheers.

 

[georgetheforge]

I get 25mm feather edge but its getting harder to get hold of- i think my last was from I S & G 0208 778 8881 i think- or the dreaded Parkers....

i might have some on my rack but aint back there till may.....

 

[Chipper]

Ta, I'll give ISG a try. Think Parkers listed square edge but will try them n'all.

 

[Tigman]

I've got an old rusty bit somewhere !

 

[Chipper]

PM coming Tigman...