Anguz Forum Supporter Messages 1,624 Location Northamptonshire May 19, 2022 #2 I would do it on its side with supports
M m_c Member Messages 2,735 Location East Lothian May 19, 2022 #3 It would depend on which way you want it strongest, and/or best cosmetic finish. I'd think vertical with tree supports would give the best finish, but on it's side is likely to be stronger.
It would depend on which way you want it strongest, and/or best cosmetic finish. I'd think vertical with tree supports would give the best finish, but on it's side is likely to be stronger.
Screwdriver Member Messages 10,150 May 19, 2022 #4 I would split it in half lengthways and glue the halves together. You can even do that in Cura, just drop it half way through the print bed (twice).
I would split it in half lengthways and glue the halves together. You can even do that in Cura, just drop it half way through the print bed (twice).