Is it possible to use a plasma cutter 100% in a cut and etch department to move away from saws entirely. Cutting 10mm-55mm MIG weld cuts to test penetration.
Using a Spectrum 625 x-treme currently with a 30a tip.
30a in 55 material?
This will be a job for my best friend.
Oxy ace.
But be aware that thermal cut will get a thermal impact.
So best way is to avoid it.
30a in 55 material?
This will be a job for my best friend.
Oxy ace.
But be aware that thermal cut will get a thermal impact.
So best way is to avoid it.