Hi everyone
There has been a post or two on here regarding people
modifying certain welders, and specifically adding a separate
Transformer to power the wire feeder and the control board.
Well I bought the above welder,
and since doing so I have been talking to Parweld in relation
to another matter, and I mentioned this, and low and
behold, Parweld do use a separate transformer for the wire feed
and the control board in the XTM301C and the XTM301S.
I have previously commented on how smooth my Parweld welds,
and now that I know why I wanted to share this info, I did not know
this at all when I bought the welder.
A short coming on Parwelds behalf as they do not mention
it in their media, at least not that I have seen.
Hope this helps someone.
Regards, paul
There has been a post or two on here regarding people
modifying certain welders, and specifically adding a separate
Transformer to power the wire feeder and the control board.
Well I bought the above welder,
and since doing so I have been talking to Parweld in relation
to another matter, and I mentioned this, and low and
behold, Parweld do use a separate transformer for the wire feed
and the control board in the XTM301C and the XTM301S.
I have previously commented on how smooth my Parweld welds,
and now that I know why I wanted to share this info, I did not know
this at all when I bought the welder.
A short coming on Parwelds behalf as they do not mention
it in their media, at least not that I have seen.
Hope this helps someone.
Regards, paul