- Messages
- 14,356
- Location
- UK
I've got a few panels that need straightening out on me tractor. I've bought replacement (original) wings and a few other panels where mine are too far gone. Some of the replacements want a little bit of repair and knocking out a few dings. Now i'm quite adept with a hammer, but do i need one of those square head jobbies or something else? Whats the best dolly to use? presumably a flat one and a radiused one would do?
I've realised that our welding sets will struggle to go down low enough to weld 0.8/1mm tin. Have to take one of the machines off 'kill' and see if i can avoid blowing it all over the floor.
I've realised that our welding sets will struggle to go down low enough to weld 0.8/1mm tin. Have to take one of the machines off 'kill' and see if i can avoid blowing it all over the floor.