Paddock stand needing some rubbery love

[graffian]

I have lost the rubber bits from a paddock stand, for bikes lacking studs in the swinger.
Thinking back to last time I used that stand, I used loadsa duck tape on the swingarm, but it
still scratched it, however it was an FJ11 so no one cared.
Any idea of common source of suitable rubber?

 

[roofman]

I have lost the rubber bits from a paddock stand for bikes lacking studs in the swinger.
Thinkin back last time I used that stand I used loadsa duck tape on the swingarm, but it
still scratched it, however it was an FJ11 so no one cared.
Any idea of common source of suitable rubber?

EPDM Roofing rubber...i have loads of off cuts, PM me your address and i will send you enough for your needs. Put it on with normal contact adhesive.

 

[JEZGUZ]

Have a nose in your local bath suppliers, they use channel shaped foam to protect the baths before fitting and it gets chucked afterwards. Get a few lengths and cut to size.

 

[voipio]

Any idea of common source of suitable rubber?

Gimp suit?

 

[dobbslc]

Gimp suit?

Yeah but what part are you going to cut out?

 

[graffian]

EPDM Roofing rubber...i have loads of off cuts, PM me your address and i will send you enough for your needs. Put it on with normal contact adhesive.

Sounds good, message sent.
I was going to chop some bits out of the floor mats of my sister in laws car, two birds one stone and all that?
I will have to go and dig out the contact adhesive.

 

[Kram]

still scratched it, however it was an FJ11 so no one cared.

An improvement even...

A big sheet is about a tenner off ebay, I have used for lots of small jobs like this.

 

[Barking Mat]

Rubber, paddock stand, studs, swingers.

Duck tape ?

Sorry, what's this thread about ?

 

[Barking Mat]

‘How To Build a Sex Room’ Trailer

Luxury interior designer Melanie Rose will help couples create the sex room of their dreams in the upcoming Netflix series.

www.netflix.com

Wife and I watched a couple of episodes, boff.

 

[dobbslc]

So it's gone from how to hold a bike up for servicing to S&M

 

[graffian]

So it's gone from how to hold a bike up for servicing to S&M

I could use a broomstick and axle stands.