Leanne1979
Acid Burn
- Messages
- 79
Hi all
Now that i have finished my welding table and finished making the ground anchors for my bike, my thoughts have turned to my next planned project. I started my hydraulic shop press today that will take me a few weekends to complete but what shall i make next?? Well lucky for me i have a few ideas and some opinions would be great. I will eventually end up making both of these eventually but which one first?
1) A sheet metal bender, this is a very simple project im sure i could finish on a nice saturday
http://www.ch601.org/tools/bendbrake/brakeplans.pdf
2) And something i have been looking at alot recently, A mini metal forge, this little baby looks so sweet and im sure will come in very handy for heating and forging metal.
Plans are here and my design will be based on the picture at the bottom of the page
http://www.zoellerforge.com/miniforge.html
Thanks all
Leanne
Now that i have finished my welding table and finished making the ground anchors for my bike, my thoughts have turned to my next planned project. I started my hydraulic shop press today that will take me a few weekends to complete but what shall i make next?? Well lucky for me i have a few ideas and some opinions would be great. I will eventually end up making both of these eventually but which one first?
1) A sheet metal bender, this is a very simple project im sure i could finish on a nice saturday
http://www.ch601.org/tools/bendbrake/brakeplans.pdf
2) And something i have been looking at alot recently, A mini metal forge, this little baby looks so sweet and im sure will come in very handy for heating and forging metal.
Plans are here and my design will be based on the picture at the bottom of the page
http://www.zoellerforge.com/miniforge.html
Thanks all
Leanne