Need to find or have a part made

[Kayos]

Any ideas where or anyone can make it, for beer tokens/charity donation? Something like this, except without the swivel so just solid

Essentially an m6 threaded rod with a solid mounted m6 thread at the top 90deg to to the threaded insert

Threaded insert needs to be 10-11mm long

 

[RonA]

Would a rose joint & a shouldered bolt not do the job? This is one example I found by a quick trawl of the net as they say on TV others may be available http://www.akbearings.co.uk/product.asp?P_ID=456
RonA

 

[Kayos]

It needs to be solid, the picture was to closest I could find

 

[Fazerruss]

So an m6 bolt welded a 90 degrees to a 6mm threaded insert?

If you are stuck then I could throw that together for you

 

[Kayos]

So an m6 bolt welded a 90 degrees to a 6mm threaded insert?

If you are stuck then I could throw that together for you

I need 4, they are for something on the rear suspension on a bmw

Happy to cover costs/postage/beer etc

 

[steviec_lj]

What model/year BMW? I’ve half a garage full of parts from 1983 to 2017

Or is this a modification?

 

[Maker]

Something like this?

The stud is loctited in place but there's no reason it couldn't be welded from the backside too. I'm happy to make a few up if that's what you were looking for?

 

[500e]

SGS engineering they are the same as on gas struts if they are held in with a wire clip
https://www.sgs-engineering.com/gas-struts/end-fixings

 

[gaz_moose]

cant you just tack weld a bolt to the top of an 'all thread' joiner?

 

[julianf]

Can you butcher a track rod end off something lightweight?

 

[Kayos]

What model/year BMW? I’ve half a garage full of parts from 1983 to 2017

Or is this a modification?

Modification, E61 with M3 wheels and...... (I fell asleep and said just give me the spec)

Something like this?
View attachment 149486
The stud is loctited in place but there's no reason it couldn't be welded from the backside too. I'm happy to make a few up if that's what you were looking for?

Yes, PM incoming

cant you just tack weld a bolt to the top of an 'all thread' joiner?

I could but my welder is buried and my welding is crap

Can you butcher a track rod end off something lightweight?

Pass, was asked if I could help so I posted here