- Thread starter AdrianH
- Start date
Bill Edwards
Member
- Messages
- 4,959
- Location
- Scarborough, North Yorkshire
312's - yep, they should do nicely 
Will have a go tomorrow then, get the grinder going to V the metal, may do the small weld on the hole first then when cooled the other sections from both sides.
Probably stupid question, but could I clean the flux off the rod and use it as a Tig rod? Or just stick it?
Adrian
Probably stupid question, but could I clean the flux off the rod and use it as a Tig rod? Or just stick it?
Adrian
OK an update - All is well with the world.
Series of pictures from after welding with use of a ceramic flap disk.
To after having the hole milled out 1/2 inch
To back in the shear and having cut some 25 x 3 mm steel flat.
So I will have to look at the current Clarke ones to get an idea of capacity again and try to remember it, or at least mark it on somewhere.
Adrian
Series of pictures from after welding with use of a ceramic flap disk.
To after having the hole milled out 1/2 inch
To back in the shear and having cut some 25 x 3 mm steel flat.
So I will have to look at the current Clarke ones to get an idea of capacity again and try to remember it, or at least mark it on somewhere.
Adrian
Bill Edwards
Member
- Messages
- 4,959
- Location
- Scarborough, North Yorkshire
Result 
Expert tuition...
Expert tuition...
